Replacing Natural Grass With Artificial Grass Option 2 (using sand only)
1. First of all assess how much grass you will need.
Mark off the area to be measured - it can help to mark it with some sort of spray can as this helps to show exactly how the grass will lie.
Note: We manufacture rolls in 2 widths: 2 metres (6 feet 6 inches) or 4 metres (13 feet 1 inch)
2. Remove the grass sod by hand for smaller areas or by using a turf cutter for larger areas.
3. You should compact the ground, using a vibrating plate which can be hired at an equipment hire centre.
4. Apply a geo-textile weed barrier to the base.
5. Lay a levelling layer of sharp sand to provide a level surface on which to lay the artificial grass. This must be no less than 10mm (approx ½ inch) and no more than 40mm (between 1 ½ inches and 1 ¾ inches) This can also be a good point to stop and put in place timber edging if you plan to use that - eg. an edge board (tanalised timber & wooden pegs).
6. Spread and compact the sub base using the vibrating plate mentioned in point 3.
7. Lay the artificial grass on top of the sand (as opposed to dragging it onto the base material) and leave for around 2 to 3 hours to settle. This helps stop any wrinkling or creasing.
8. Cut and trim your artificial grass, using a sharp Stanley knife.
9. Make the joins using the correct type of seaming tape and glue - only quality outdoor tape and glue should be used. We recommend you purchase this from us when placing your order.
10. Apply the infill as specified. Typically a sand mix will be used . Rake and spread the infill evenly, taking care not to over fill the surface. Note: Application of sand is best on a dry day. Remember that the infill will eventually compact so you should consider adding a final layer when settled.
11. Apply any natural stone, paving or log roll edgings you've selected. If you've chosen not to use edgings, then apply landscaping nails every 50mm (2 inches) or so.
Note: We manufacture rolls in 2 widths: 2 metres (6 feet 6 inches) or 4 metres (13 feet 1 inch)
2. Remove the grass sod by hand for smaller areas or by using a turf cutter for larger areas.
3. You should compact the ground, using a vibrating plate which can be hired at an equipment hire centre.
4. Apply a geo-textile weed barrier to the base.
5. Lay a levelling layer of sharp sand to provide a level surface on which to lay the artificial grass. This must be no less than 10mm (approx ½ inch) and no more than 40mm (between 1 ½ inches and 1 ¾ inches) This can also be a good point to stop and put in place timber edging if you plan to use that - eg. an edge board (tanalised timber & wooden pegs).
6. Spread and compact the sub base using the vibrating plate mentioned in point 3.
7. Lay the artificial grass on top of the sand (as opposed to dragging it onto the base material) and leave for around 2 to 3 hours to settle. This helps stop any wrinkling or creasing.
8. Cut and trim your artificial grass, using a sharp Stanley knife.
9. Make the joins using the correct type of seaming tape and glue - only quality outdoor tape and glue should be used. We recommend you purchase this from us when placing your order.
10. Apply the infill as specified. Typically a sand mix will be used . Rake and spread the infill evenly, taking care not to over fill the surface. Note: Application of sand is best on a dry day. Remember that the infill will eventually compact so you should consider adding a final layer when settled.
11. Apply any natural stone, paving or log roll edgings you've selected. If you've chosen not to use edgings, then apply landscaping nails every 50mm (2 inches) or so.
